Cisco ONS 15310-CL Troubleshooting Manual page 290

Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-2218 Bandwidth must be between {0} and {1} percent.
EID-2219 Protection operation failed, XC loopback is applied on
cross-connection.
EID-2220 The tunnel status is PARTIAL. CTC will not be able to change
it. Please try again later
EID-2221 Cannot find a valid route for the unprotected to {0} upgrade
request.
EID-2222 One or more of the following nodes are currently part of a
4-fiber {0}. Only a single 4-fiber {0} is supported per node.
{1}
EID-2223 Only one circuit can be upgraded at a time.
EID-2224 This link may not be included as it terminates on the source.
EID-2225 No valid signal while trying to complete the roll. (0)
EID-2226 Circuit roll failure.
{0}
EID-2320 This VCAT circuit does not support deletion of its member
circuits.
EID-2321 Error deleting member circuits.
{0}
WID-2322 Not all cross-connects from selected circuits could be merged
into the current circuit. They may appear as partial circuits.
EID-2323 Circuit roll failure.
Bridge and roll is not supported on a monitor circuit.
EID-2324 Circuit upgrade error.
{0}
EID-2325 You have failed {0} times to unlock this session. CTC will exit
after you click OK or close this dialog box.
WID-2326 Currently, CTC does not support bridge and roll on circuits that
are entirely created by TL1. To continue with bridge and roll in
CTC, selected circuits must be upgraded.
OK to upgrade selected circuits and continue bridge and roll
operation?
WID-2327 Currently, CTC does not support bridge and roll on circuits that
are partially created by TL1. To continue with bridge and roll
in CTC, selected circuits must be upgraded.
OK to upgrade selected circuits and continue bridge and roll
operation?
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-14
Chapter 1
Description
The bandwidth must be within the specified
parameters.
As the protection operation failed, a
cross-connect (XC) loopback will be
applied on cross-connection.
Refer to the error message text.
Refer to the error message text.
The nodes, specified by {1}, are already
part of a 4-fiber BLSR/MS-SPRing type
(specified by {0}).
Refer to the error message text.
Refer to the error message text.
Roll can be completed only when a valid
signal is detected. If not, the roll completion
may result in an error.
Refer to the error message text.
You can not delete a circuit that is a member
of VCAT circuit.
Refer to the error message text.
Refer to the warning message text.
A monitor circuit does not support Bridge
and Roll.
Refer to the error message text.
The maximum amount of attempts to
unlock this session has been reached.
Refer to the warning message text.
Refer to the warning message text.
Error Messages
78-17235-01