Cisco ONS 15310-CL Troubleshooting Manual page 289

Chapter 1 Error Messages
Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-2195 The circuit VLAN list cannot be mapped to one spanning tree.
You can view the VLAN/Spanning Tree table or reassign
VLANs.
EID-2196 Unable to relaunch the CTC. {0}
EID-2197 CORBA failure. Unable to proceed.
EID-2198 Unable to switch to the {0} view.
EID-2199 Login failed on {0} {1}
EID-2200 CTC has detected a jar file deletion. The jar file was used to
manage one or more nodes. This CTC session will not be able
to manage those nodes and they will appear gray on the network
map. It is recommended that you exit this CTC session and start
a new one.
EID-2202 Intra-node circuit must have two sources to be Dual Ring
Interconnect.
EID-2203 No member selected.
EID-2204 Number of circuits must be a positive integer
EID-2205 Circuit Type must be selected.
EID-2206 Unable to autoselect profile! Please select profile(s) to store
and try again.
EID-2207 You cannot add this span. Either the ring name is too big (i.e.,
ring name length is greater than {0}) or the endpoints do not
support alphanumeric IDs.
EID-2208 This is an invalid or unsupported JRE.
EID-2209 The user name must be at least {0} characters long.
EID-2210 No package name selected.
EID-2211 No node selected for upgrade.
EID-2212 Protected Line is not provisionable.
WID-2213 The current type or state of some drops does not allow the new
circuit state of {0} to be applied to them indirectly.
EID-2214 The node is disconnected. Please wait till the node reconnects. Refer to the error message text.
EID-2215 Error while leaving {0} page.
EID-2216 Error while entering {0} page.
EID-2217 Some conditions could not be retrieved from the network view Refer to the error message text.
78-17235-01
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Description
Refer to the error message text.
There is an error relaunching CTC.
There was a CORBA failure, and the task
cannot proceed. Verify the Java version.
CTC is unable to switch to the specified
view.
The login failed on the specified tasks.
Refer to the error message text.
Intranode circuit must have two sources to
be a dual ring interconnect (DRI).
You must select a member.
The number of circuits cannot be zero or
negative.
You must select a circuit type.
Refer to the error message text.
Reduce the length of the ring name, or
remove the alphanumberic characters from
the end points.
The version of Java Runtime Environment
(JRE) is either invalid or unsupported.
The user name must be at least of the
specified character length.
You must select a package name.
You must select a node for the upgrade.
The protected line cannot be provisioned.
Choose another line.
The circuit state, specified by {0} cannot be
applied to the selected drops.
There was an error while leaving the
specified page.
There was an error while entering the
specified page.
1-13