Cisco ONS 15310-CL Troubleshooting Manual page 286

Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-2130 The ring ID value, {0}, is not valid. Please enter a valid number
between 0 and 9999.
EID-2131 Cannot set reversion to INCONSISTENT.
EID-2135 Unable to store overhead circuit preferences:
{0}
EID-2137 Circuit merge error. {0}
EID-2138 Cannot delete all destinations. Please try again.
EID-2139 Error updating destinations.
EID-2143 No online help version selected. Cannot delete the online help
book.
EID-2144 Error deleting online help book(s).
{0}
EID-2145 Unable to locate a node with an IOS card.
EID-2146 Security violation. You may only logout your own account.
EID-2147 Security violation. You may only change your own account.
EID-2148 Security violation. You may not delete the account under which
you are currently logged in.
WID-2149 There is nothing exportable on this view.
WID-2150 Node {0} is not initialized. Please wait and try again.
WID-2152 Spanning tree protection is being disabled for this circuit.
WID-2153 Adding this drop makes the circuit a PCA circuit.
WID-2154 Disallow creating monitor circuits on a port grouping circuit.
WID-2155 Only partial switch count support on some nodes.
{0}
WID-2156 Manual roll mode is recommended for dual rolls. For auto dual
rolls, please verify that roll to facilities are in service and error
free.
WID-2157 Cannot complete roll(s).
{0}
EID-2158 Invalid roll mode.
{0}
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-10
Chapter 1
Description
Enter a ring ID value between 0 and 9999.
You must select another reversion type.
Input/Output error. Unable to store
overhead circuit preferences.
There was an error while merging the
circuits.
Refer to the error message text.
There was an error in updating the circuit
destinations.
Select the version of online help, and
proceed.
You cannot delete the specified online help.
Refer to error message.
You cannot logout of an account other than
your own.
You cannot change an account other than
your own.
You cannot delete the account you are
currently loggd in.
Refer to the error message text.
Wait till the specified node is initialized and
try again.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
The specified nodes do not support switch
counts completely.
Refer to the warning message text.
CTC could not complete the roll because
the roll is destroyed, in an incomplete state,
in a TL1_roll state, is cancelled, or is not
ready to complete.
There are two roll modes: auto and manual.
For a one-way circuit source roll, the roll
mode must be auto and for a one- way
circuit destination roll, the roll mode must
be manual.
Error Messages
78-17235-01