Cisco ONS 15310-CL Troubleshooting Manual page 304

Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3323 APC system is busy.
EID-3324 No path to regulate.
EID-3325 Requested action not allowed.
EID-3326 Wrong input value.
EID-3327 Error in getting thresholds.
EID-3328 Error applying changes to row {0}.Value out of range.
EID-3330 Unable to switch to the byte because an overhead channel is
present on this byte of the port.
EID-3331 Error applying changes to row.
EID-3334 Cannot change timing parameters on protect port.
EID-3335 The type of this port cannot be changed: SDH validation check
failed. Check if this port is part of a circuit, protection group,
SONET DCC, orderwire, or UNI-C interface.
EID-3336 Error on reading a control mode value.
EID-3337 Error on setting a set point gain value.
EID-3338 Error on reading a set-point gain value.
EID-3339 Error on setting a tilt calibration value.
EID-3340 Error on setting expected wavelength.
EID-3341 Error on reading expected wavelength.
EID-3342 Error on reading actual wavelength.
EID-3343 Error on reading actual band.
EID-3344 Error on reading expected band.
EID-3345 Error on setting expected band.
EID-3346 Error retrieving defaults from the node: {0}.
EID-3347 Cannot load file {0}.
EID-3348 Cannot load properties from the node.
EID-3349 Cannot save NE Update values to file.
EID-3350 Cannot load NE Update properties from the node:
EID-3351 File {0} does not exist.
EID-3352 Error on setting value at {0}.
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-28
Chapter 1
Description
Automatic Power Control (APC) system is
busy.
There is no circuit path to regulate.
Generic DWDM provisioning failure
message.
The input value is incorrect.
There was an error retrieving the thresholds.
This message is displayed only for the
OSCM/OSC-CSM line thresholds.
There was an error applying the changes to
the specified row. The value is out of range.
Refer to the error message text.
Refer to the error message text.
You cannot change timing parameters on
protect port.
Refer to the error message text.
The Control Mode must be retrieved.
The Gain Set Point must be set.
The Gain Set Point must be retrieved.
The tilt calibration must be set.
The expected wavelength must be set.
The expected wavelength must be retrieved.
The actual wavelength must be retrieved.
The actual band must be retrieved.
The expected band must be retrieved.
The expected band must be set.
There was an error retrieving defaults from
the specified node.
CTC cannot load the specified file.
Refer to the error message text.
Check your file system for space constraint
or any other problem.
Refer to the error message text.
The specified file does not exist.
There was an error while setting the value at
the specified location.
Error Messages
78-17235-01