Cisco ONS 15310-CL Troubleshooting Manual page 280

Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-2003 Error deleting roll.
EID-2004 No IOS slot selected.
EID-2005 CTC cannot find the online help files for {0}. The files may
have been moved, deleted, or not installed. To install online
help, run the setup program on the software or documentation
CDs.
EID-2006 Error editing circuit(s). {0} {1}.
EID-2007 Unable to save preferences.
EID-2008 Unable to store circuit preferences: {0}
EID-2009 Unable to download package:
{0}
EID-2010 Delete destination failed.
EID-2011 Circuit destroy failed.
EID-2012 Reverse circuit destroy failed.
EID-2013 Circuit creation error. Circuit creation cannot proceed due to
changes in the network which affected the circuit(s) being
created. The dialog will close. Please try again.
EID-2014 No circuit(s) selected. {0}
EID-2015 Unable to delete circuit {0}as it has one or more rolls.
EID-2016 Unable to delete circuit.
EID-2017 Error mapping circuit. {0}
EID-2018 Circuit roll failure. The circuit has to be in the DISCOVERED
state in order to perform a roll.
EID-2019 Circuit roll failure. Bridge and roll is not supported on a
DWDM circuit.
EID-2020 Circuit roll failure. The two circuits must have the same
direction.
EID-2021 Circuit roll failure. The two circuits must have the same size.
EID-2022 Circuit roll failure. A maximum of two circuits can be selected
for a bridge and roll operation.
EID-2023 Unable to create new user account.
EID-2024 Node selection error.
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-4
Chapter 1
Description
There was an error when CTC tried to delete
the roll.
You did not select a Cisco IOS slot.
CTC cannot find the online help files for the
specified window. The files might have
been moved, deleted, or not installed. To
install online help, run the setup program on
the software CD.
An error occurred when CTC tried to open
the circuit for editing.
CTC cannot save the preferences.
CTC cannot find the file needed to save the
circuit preferences.
Refer to the error message text.
CTC could not delete the destination.
CTC could not destroy the circuit.
CTC could not reverse the circuit destroy.
Refer to the error message text.
You must select a circuit to complete this
function.
You must delete the rolls in the circuit
before deleting the circuit itself.
CTC could not delete the tunnel as there are
circuits that use the tunnel.
There was an error mapping the circuit.
There was a failure in circuit roll. Change
the circuit state to DISCOVERED and
proceed.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
There was an error during node selection.
Error Messages
78-17235-01