Physical Card Reseating And Replacement; Remove And Reinsert (Reseat) A Card; Physically Replace A Card - Cisco ONS 15310-CL Troubleshooting Manual

Chapter 1 Alarm Troubleshooting
The reset options are enabled only in the OOS-MA,MT service state.
Note
Before you reset the 15310-CL-CTX or CTX2500, you should wait at least 60 seconds after the last
Note
provisioning change you made to avoid losing any changes to the database.
Log into a node on the network. If you are already logged in, continue with
Step 1
Right-click the active 15310-CL-CTX or CTX2500 in CTC.
Step 2
Choose Hard-Reset Card or Soft-Reset Card from the shortcut menu.
Step 3
Hard-resetting a 15310-CL-CTX or CTX2500 can cause a traffic hit. A soft reset causes a traffic hit only
Caution
if a provisioning change or firmware upgrade has occurred. This can be traffic-affecting. To preserve
traffic flow, perform a traffic switch in the
section on page 1-148
Note
Click Yes in the Confirmation Dialog box.
Step 4
If you performed a hard reset, the connection to the node is lost. CTC switches to network view.
Verify that the reset is complete and error-free and that no new related alarms appear in CTC. For LED
Step 5
appearance, see the

1.10.3 Physical Card Reseating and Replacement

Remove and Reinsert (Reseat) a Card

Open the card ejectors.
Step 1
Slide the card halfway out of the slot along the guide rails.
Step 2
Slide the card all the way back into the slot along the guide rails.
Step 3
Close the ejectors.
Step 4

Physically Replace a Card

Open the card ejectors.
Step 1
Slide the card out of the slot.
Step 2
Open the ejectors on the replacement card.
Step 3
78-17235-01
as appropriate.
The hard-reset option is enabled only when the card is placed in the OOS-MA,MT service state.
"1.9.2 Typical Card LED Activity During Reset" section on page
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1.10.3 Physical Card Reseating and Replacement
"1.10.1 Protection Switching, Lock Initiation, and Clearing"
Step 2.
1-148.
1-155