Admin-Suspend-Clr; Aud-Archive-Fail; Dbbackup-Fail; Dbrestore-Fail - Cisco ONS 15310-CL Troubleshooting Manual

Chapter 1 Transient Conditions

1.3.7 ADMIN-SUSPEND-CLR

The Suspend User Clear (ADMIN-SUSPEND-CLR) condition occurs when the user or administrator
changes the password.
This transient condition does not result in a standing condition.

1.3.8 AUD-ARCHIVE-FAIL

The Archive of AuditLog Failed (AUD-ARCHIVE-FAIL) condition occurs when the software fails to
archive the audit log. The condition normally occurs when the user refers to an FTP server that does not
exist or uses an invalid login while trying to archive. The user must log in again using the correct user
name, password, and FTP server details.
This transient condition does not lead to a standing condition.

1.3.9 DBBACKUP-FAIL

The Database Backup Failed (DBBACKUP-FAIL) condition occurs when the system fails to back up the
database when the backup command is initiated.
This condition can occur when the server is not able to handle the backup operation due to network or
server issues. Repeat the same operation again and check to see if it is successful. If the backup fails, it
could be due to a network issue or software program failure.

1.3.10 DBRESTORE-FAIL

The Database Restore Failed (DBRESTORE-FAIL) condition occurs when the system fails to restore the
backed up database when the restore command is initiated.
This condition can be due to server issues, network issues, or human error (pointing to a file that does
not exist, wrong file name, etc.). Retrying the database restore with the correct file will usually succeed.
If the network issue persists, you must contact network lab support. If the condition is caused by a
network element (NE) failure, contact Cisco TAC for assistance.

1.3.11 FIREWALL-DIS

The Firewall Has Been Disabled (FIREWALL-DIS) condition occurs when you provision the firewall to
Disabled.
This transient condition does not result in a standing condition.

1.3.12 FRCDWKSWBK-NO-TRFSW

The Forced Switch Back to Working Resulted in No Traffic Switch (FRCDWKSWBK-NO-TRFSW)
condition occurs when you perform a Force Switch to the working port/card and the working port/card
is already active.
This transient condition might result in a Force Switch (Ring or Span) standing condition.
78-17235-01
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1.3.7 ADMIN-SUSPEND-CLR
1-5