Fe-Manwkswpr-Span; Feprlf; Clear The Feprlf Alarm; Forced-Req - Cisco ONS 15310-CL Troubleshooting Manual

Chapter 1 Alarm Troubleshooting

1.7.88 FE-MANWKSWPR-SPAN

The FE-MANWKSWPR-SPAN condition is not used in the ONS 15310 platforms in this release. It is
reserved for development.

1.7.89 FEPRLF

The Far End Protection Line Failure alarm occurs when an APS channel
occurs on the protect port coming into the node.
Note The FEPRLF alarm occurs when bidirectional protection is used on optical ports in a 1+1 protection
group configuration.

Clear the FEPRLF Alarm

To troubleshoot the FE alarm, determine which node and port link directly to the port reporting the FE
Step 1
alarm.
Log into the node that links directly to the port reporting the FE condition.
Step 2
Clear the main alarm. Refer to the appropriate alarm section in this chapter for instructions.
Step 3
If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport
Step 4
for more information or call Cisco TAC (1 800 553-2447).

1.7.90 FORCED-REQ

The Force Switch Request on Facility or Port condition occurs when you enter the Force command on a
port to force traffic from a working port to a protect port or protection span (or from a protect port to a
working port or span). You do not need to clear the condition if you want the Force switch to remain.

Clear the FORCED-REQ Condition

Step 1 Complete the
Step 2 If the condition does not clear, log into the Technical Support Website at
http://www.cisco.com/techsupport for more information or call Cisco TAC (1 800 553-2447).
78-17235-01
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
SONET Logical Object: OCN
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SONET Logical Objects: STSMON, VT-MON
"Clear a 1+1 Force or Manual Switch Command" procedure on page
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1.7.88 FE-MANWKSWPR-SPAN
"SF-L" condition on page 1-127
1-150.
1-65