Access-List (Ip Standard) - Cisco Catalyst 2950 Command Reference Manual

access-list (IP standard)

access-list (IP standard)
Use the standard version of the access-list global configuration command to configure a standard IP
access control list (ACL). Use the no form of this command to remove a standard IP ACL.
This command is available on physical interfaces only if your switch is running the enhanced software
image (EI).
Syntax Description
access-list-number
deny
permit
remark
source source-wildcard |
host source | any
Defaults The default standard ACL is always terminated by an implicit deny statement for all packets.
Command Modes Global configuration
Command History Release
12.1(6)EA2
Catalyst 2950 and Catalyst 2955 Switch Command Reference
2-8
access-list access-list-number {deny | permit | remark} {source source-wildcard | host source |
any}
no access-list access-list-number
Number of an ACL. The range is 1 to 99 and1300 to 1999.
Deny access if conditions are matched.
Permit access if conditions are matched.
ACL entry comment up to 100 characters.
Define a source IP address and wildcard.
The source is the source address of the network or host from which the
packet is being sent, specified in one of these ways:
Modification
This command was introduced.
The 32-bit quantity in dotted-decimal format. The source-wildcard
•
applies wildcard bits to the source.
The keyword host, followed by the 32-bit quantity in dotted-decimal
•
format, as an abbreviation for source and source-wildcard of source
0.0.0.0.
The keyword any as an abbreviation for source and source-wildcard
•
of 0.0.0.0 255.255.255.255. You do not need to enter a
source-wildcard.
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
OL-10102-01