Cisco Catalyst 2950 Command Reference Manual page 100

cpe duplex
This example shows how to set a port on a Cisco 585 LRE CPE to full-duplex mode:
Switch# configure terminal
Switch(config)# interface longreachethernet0/3
Switch(config-if)# cpe duplex full port 3
This example shows how to restore a port on a Cisco 585 LRE CPE to the default mode of half duplex:
Switch# configure terminal
Switch(config)# interface longreachethernet0/3
Switch(config-if)# no cpe duplex full port 3
This example shows how the cpe duplex {auto | full | half} port port-id command works with the cpe
duplex {auto | full | half} command. Port 1 is set to full duplex, port 2 is set to half duplex, and the
remainder of the ports are set to autonegotiate.
Switch# configure terminal
Switch(config)# interface longreachethernet0/4
Switch(config-if)# cpe duplex auto
Switch(config-if)# cpe duplex full port 1
Switch(config-if)# cpe duplex half port 2
After the commands in the previous example are entered, this example shows how to set a port to
autonegotiate:
Switch(config-if)# no cpe duplex full port 1
Related Commands Command
cpe speed
show interfaces
Catalyst 2950 and Catalyst 2955 Switch Command Reference
2-70
Description
Specifies the CPE port speed settings.
cpe Displays CPE Ethernet ports connection, speed, or duplex status.
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
OL-10102-01