Cisco Catalyst 2950 Command Reference Manual page 150

hw-module slot
This example shows what happens when you attempt to update current firmware without using the force
option:
Switch# hw-module slot 0 upgrade lre remote longreachethernet0/1
You are about to start an LRE upgrade on CPE Lo0/1.
Users on LRE links being upgraded will experience a temporary
disruption of Ethernet connectivity.
Start LRE upgrade ? [yes]:
No upgrade required on CPE Lo0/1
This example shows how to use the force option when you attempt to update current firmware on a CPE:
Switch# hw-module slot 0 upgrade lre force remote longreachethernet0/1
You are about to start an LRE upgrade on CPE Lo0/1.
Users on LRE links being upgraded will experience a temporary
disruption of Ethernet connectivity.
Start LRE upgrade ? [yes]:
Starting remote upgrade on CPE Lo0/1
Switch#
Related Commands Command
controller longreachethernet
show lre upgrade
Catalyst 2950 and Catalyst 2955 Switch Command Reference
2-120
Chapter 2
Description
Allows you to enter controller mode.
Displays the LRE binaries present on the system flash memory, the
upgrade status on all ports in the switch, or the binaries on local
and remote ends on all ports.
Catalyst 2950 and 2955 Cisco IOS Commands
OL-10102-01