Cisco Catalyst 2950 Command Reference Manual page 103

Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
After the cpe shutdown port 2 command was entered in the previous example, this example shows how
to enable all the CPE Ethernet ports that were not shut down. After the no cpe shutdown command is
entered, port 2 is still shut down because the cpe shutdown port 2 command was entered in the previous
example. Use the no cpe shutdown port 2 command to enable the port 2.
Switch# configure terminal
Switch(config)# interface longreahethernet0/2
Switch(config-if)# no cpe shutdown
Switch(config-if)#
Related Commands Command
show interfaces
shutdown
OL-10102-01
Description
cpe Displays CPE Ethernet ports connection, speed, or duplex status.
Disables a port.
Catalyst 2950 and Catalyst 2955 Switch Command Reference
cpe shutdown
2-73