Lre Sequence - Cisco Catalyst 2950 Command Reference Manual

lre sequence

lre sequence
Use the lre sequence global configuration command to define a new sequence and to enter sequence
configuration mode. Use the no form of this command to delete a user-configured sequence.
This command is available only on Catalyst 2950 Long-Reach Ethernet (LRE) switches.
Syntax Description sequence-name
Defaults No default is defined.
Command Modes
Global configuration
Command History Release
12.1(11)YJ
Usage Guidelines This command creates a new sequence when the sequence name specified in the command does not
match any of the existing configured sequences. When the sequence name specified in the command
matches a configured sequence, a new sequence is not created.
The profiles can be edited from the sequence configuration mode. However, the system-defined
sequences cannot be edited. If the sequence specified in this command is a system-defined sequence, the
command is rejected. An error message appears if the sequence name matches the name of a
system-defined sequence. Use the exit command to return to global configuration mode.
Examples
This example shows how to specify the a user-defined sequence called myseq:
Switch# configure terminal
Switch(config)# lre sequence myseq
Switch(config-seq)#
This example shows how to create a user-defined sequence called corpseq, with two profiles in that
sequence:
Switch# configure terminal
Switch(config)# lre sequence corpseq
Switch(config-seq)# profile lre-15-5
Switch(config-seq)# profile lre-15-3
Switch(config-seq)# exit
Switch(config)#
Catalyst 2950 and Catalyst 2955 Switch Command Reference
2-178
lre sequence sequence-name
no lre sequence sequence-name
Name of the sequence being created or modified.
Modification
This command was introduced.
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
OL-10102-01