Lre Rate Selection Sequence - Cisco Catalyst 2950 Command Reference Manual

lre rate selection sequence

lre rate selection sequence
Use the lre rate selection sequence global configuration command to assign the rate selection sequence
for the entire switch. Use the no form of the command to delete the assigned sequence.
This command is available only on Catalyst 2950 Long-Reach Ethernet (LRE) switches.
Syntax Description sequence-name
Command Modes Global configuration
Command History Release
12.1(11)YJ
Usage Guidelines This command applies a sequence to all ports that have rate selection enabled. The command is rejected
if the sequence is not configured with a profile.
When rate selection is enabled, profiles and sequences follow a predefined priority scheme that
determines the rate for a port or for the entire switch. In general, sequences have priority over standalone
profiles, and port configurations have priority over global configurations. These are the priority levels
with rate selection enabled, from highest to lowest:
1.
2.
3.
4.
For further details on profiles, sequences, and their priority scheme, see the switch software
configuration guide for this release.
Examples This example shows how to specify the sequence named lre-seq-upstream:
Switch# configure terminal
Switch(config)# lre rate selection sequence lre-seq-upstream
Catalyst 2950 and Catalyst 2955 Switch Command Reference
2-176
lre rate selection sequence sequence-name
no lre rate selection sequence sequence-name
Name of the rate selection sequence being applied.
Modification
This command was introduced.
Per-port sequence
Global sequence
Port profile
Global profile
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
OL-10102-01