Cisco Catalyst 2950 Command Reference Manual page 404

show mls masks
Examples This is an example of output from the show mls masks command:
Switch> show mls masks
Mask1
Mask2
In this example, Mask 1 is a QoS ACP consisting an IP source address (with wildcard bits 0.0.0.255), an
IP destination address, and Layer 4 destination port fields. This ACP is used by the QoS policy maps
pmap1 and pmap2.
Mask 2 is a security ACP consisting of a MAC source address and ethertype fields. This ACP is used by
the MAC security access groups 3 and macag1.
Related Commands Command
ip access-group
mac access-group
policy-map
Catalyst 2950 and Catalyst 2955 Switch Command Reference
2-376
Type : qos
Fields : ip-sa(0.0.0.255), ip-da(host), dest-port, ip-dscp
Policymap: pmap1
Interfaces: Fa0/9, Gi0/1
Policymap: pmap2
Interfaces: Fa0/1, Fa0/5, Fa0/13
Type : security
Fields : mac-sa (host), ethertype, ip-dscp
Access-group: 3
Interfaces: Fa0/2, Fa0/6
Access-group: macag1
Interfaces: Fa0/16
Description
Applies an IP ACL to an interface.
Applies a named extended MAC ACL to an interface.
Creates or modifies a policy map that can be attached to multiple interfaces,
and enters policy-map configuration mode.
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
0L-10102-01