Show Mls Qos Interface - Cisco Catalyst 2950 Command Reference Manual

Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands

show mls qos interface

Use the show mls qos interface user EXEC command to display quality of service (QoS) information
at the interface level.
Syntax Description interface-id
policers
| begin
| exclude
| include
expression
Though visible in the command-line help strings, the vlan vlan-id option is not supported.
Note
Command Modes User EXEC
Command History Release
12.1(6)EA2
Usage Guidelines Though visible in the command-line help string, the policers keyword is available only when your
switch is running the EI.
Use the show mls qos interface command without keywords to display parameters for all interfaces.
Use the show mls qos interface interface-id command to display the parameters for a specific interface.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show mls qos interface command when the Cisco IP phone is a
trusted device:
Switch> show mls qos interface fastethernet0/1
FastEthernet0/1
trust state:trust cos
trust mode:trust cos
COS override:dis
default COS:0
pass-through:none
trust device:cisco-phone
0L-10102-01
show mls qos interface [interface-id] [policers] [ | {begin | exclude | include} expression]
(Optional) Display QoS information for the specified interface.
(Optional) Display all the policers configured on the interface and their
settings (available only when the switch is running the enhanced image
[EI]).
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Catalyst 2950 and Catalyst 2955 Switch Command Reference
show mls qos interface
2-377