Debug Auto Qos - Cisco Catalyst 2950 Command Reference Manual

debug auto qos

debug auto qos
Use the debug auto qos privileged EXEC command to enable debugging of the automatic quality of
service (auto-QoS) feature. Use the no form of this command to disable debugging.
Syntax Description
This command has no arguments or keywords.
Defaults Auto-QoS debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.1(12c)EA1
12.1(20)EA2
Usage Guidelines To display the QoS configuration that is automatically generated when auto-QoS is enabled, enable
debugging before you enable auto-QoS. You enable debugging by entering the debug auto qos
privileged EXEC command.
The undebug auto qos command is the same as the no debug auto qos command.
Examples This example shows how to display the QoS configuration that is automatically generated when
auto-QoS is enabled:
Switch# debug auto qos
AutoQoS debugging is on
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# interface fastethernet0/1
Switch(config-if)# auto qos voip cisco-phone
00:02:54:wrr-queue bandwidth 10 20 70 1
00:02:55:no wrr-queue cos-map
00:02:55:wrr-queue cos-map 1 0 1
00:02:56:wrr-queue cos-map 2 2 4
00:02:57:wrr-queue cos-map 3 3 6 7
00:02:58:wrr-queue cos-map 4 5
00:02:59:mls qos map cos-dscp 0 8 16 26 32 46 48 56
00:03:00:interface FastEthernet0/1
00:03:00: mls qos trust device cisco-phone
00:03:00: mls qos trust cos
Catalyst 2950 and Catalyst 2955 Switch Command Reference
C-2
debug auto qos
no debug auto qos
Modification
This command was introduced.
The command changed from debug autoqos to debug auto qos.
Appendix C Catalyst 2950 and 2955 Switch Debug Commands
End with CNTL/Z.
OL-10102-01