Mvr Vlan Group - Cisco Catalyst 2950 Command Reference Manual

Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands

mvr vlan group

Use the mvr vlan group interface configuration command to statically configure a receiver port as a
member of a multicast VLAN registration (MVR) group in a particular VLAN. Use the no form of this
command to remove the port from the MVR group.
Syntax Description
vlan vlan-id
group ip-address
Defaults
A port is configured as neither receiver nor source.
Command Modes Interface configuration
Command History Release
12.1(6)EA2
Usage Guidelines
The receiver port belongs to a multicast VLAN.
The group address is configured as a MVR group address.
Examples This example shows how to configure a static MVR group entry on port 1 in VLAN 10:
Switch(config)# interface fastethernet0/1
Switch(config-if)# mvr vlan 10 group 225.1.1.1
This example shows how to remove an entry on port 3 in VLAN 10:
Switch(config)# interface fastethernet0/3
Switch(config-if)# no mvr 10 group 255.1.1.2
You can verify your settings by entering the show mvr privileged EXEC command.
OL-10102-01
mvr vlan vlan-id group ip-address
no mvr vlan vlan-id group ip-address
Specify the VLAN ID to which the receiver port belongs. The range is 1 to
4094.
Specify the MVR group address for which the interface is statically
configured to be a member.
Modification
This command was introduced.
Catalyst 2950 and Catalyst 2955 Switch Command Reference
mvr vlan group
2-229