Cluster Run - Cisco Catalyst 2950 Command Reference Manual

cluster run

cluster run
Use the cluster run global configuration command to enable clustering on a switch. Use the no form of
this command to disable clustering on a switch.
Defaults
Clustering is enabled on all switches.
Command Modes Global configuration
Command History Release
12.0(5.2)WC(1)
Usage Guidelines
When you enter the no cluster run command on a command switch, the command switch is disabled.
Clustering is disabled, and the switch cannot become a candidate switch.
When you enter the no cluster run command on a member switch, it is removed from the cluster.
Clustering is disabled, and the switch cannot become a candidate switch.
When you enter the no cluster run command on a switch that is not part of a cluster, clustering is
disabled on this switch. This switch cannot then become a candidate switch.
Examples
This example shows how to disable clustering on the command switch:
Switch(config)# no cluster run
You can verify that clustering is disabled by entering the show cluster privileged EXEC command.
Related Commands Command
show cluster
Catalyst 2950 and Catalyst 2955 Switch Command Reference
2-64
cluster run
no cluster run
Modification
This command was introduced.
Description
Displays the cluster status and a summary of the cluster to which the switch
belongs.
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
OL-10102-01