Rcommand - Cisco Catalyst 2950 Command Reference Manual

rcommand

rcommand
Use the rcommand user EXEC command to start a Telnet session and to enter commands from a cluster
command switch for a member switch. To end the session, enter the exit command.
Syntax Description n
commander
mac-address hw-addr
Command Modes User EXEC
Command History Release
12.0(5.2)WC(1)
Usage Guidelines If the switch is the cluster command switch but the member switch n does not exist, an error message
appears. To obtain the switch number, enter the show cluster members privileged EXEC command on
the command switch.
You can use this command to access a member switch from the command-switch prompt or to access a
command switch from the member-switch prompt.
For Catalyst 2900 XL, 2940, 2950, 2955, 3500 XL, and 3550 switches, the Telnet session accesses the
member-switch command-line interface (CLI) at the same privilege level as on the command switch. For
example, if you enter this command at user level on the cluster command switch, the member switch is
accessed at user level. If you use this command on the command switch at privileged level, the command
accesses the remote device at privileged level. If you use an intermediate enable-level lower than
privileged, access to the member switch is at user level.
For Catalyst 1900 and 2820 switches running standard edition software, the Telnet session accesses the
menu console (the menu-driven interface) if the command switch is at privilege level 15. If the command
switch is at privilege level 1, you are prompted for the password before being able to access the menu
console. Command switch privilege levels map to the member switches running standard edition
software as follows:
•
•
This command does not work if the vty lines of the command switch have access-class configurations.
You are not prompted for a password because the member switches inherited the password of the
command switch when they joined the cluster.
Catalyst 2950 and Catalyst 2955 Switch Command Reference
2-256
rcommand {n | commander | mac-address hw-addr}
Provide the number that identifies a cluster member. The range is 0 to 15.
Provide access to the command switch from a member switch.
MAC address of the member switch.
Modification
This command was introduced.
If the command switch privilege level is from 1 to 14, the member switch is accessed at privilege
level 1.
If the command switch privilege level is 15, the member switch is accessed at privilege level 15.
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
OL-10102-01