Cisco Catalyst 2950 Command Reference Manual page 417

Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
This is an example of output from the show pagp 1 internal command:
Switch> show pagp 1 internal
Flags:
Timers: H - Hello timer is running.
Channel group 1
Port
Fa0/1
Fa0/2
This is an example of output from the show pagp 1 neighbor command:
Switch> show pagp 1 neighbor
Related Commands Command
clear pagp
pagp learn-method
0L-10102-01
S - Device is sending Slow hello.
A - Device is in Auto mode.
S - Switching timer is running.
Flags State Timers
SC U6/S7 H
SC U6/S7 H
Flags: S - Device is sending Slow hello.
A - Device is in Auto mode.
Channel group 1 neighbors
Partner
Port Name
Fa0/1 device-p2
Fa0/2 device-p2
Description
Clears PAgP channel-group information.
Sets the source-address learning method of incoming packets received
from an EtherChannel port.
C - Device is in Consistent state.
Q - Quit timer is running.
I - Interface timer is running.
Hello Partner PAgP
Interval Count Priority
30s 1 128
30s 1 128
C - Device is in Consistent state.
P - Device learns on physical port.
Partner Partner
Device ID Port
0002.4b29.4600 Fa0/1
0002.4b29.4600 Fa0/2
Catalyst 2950 and Catalyst 2955 Switch Command Reference
show pagp
Learning Group
Method Ifindex
Any 16
Any 16
Partner Group
Age Flags Cap.
9s SC 10001
24s SC 10001
2-389