Local Speed - Cisco Catalyst 2950 Command Reference Manual

local speed

local speed
Use the local speed interface configuration command to specify the speed of a Long-Reach Ethernet
(LRE) interface. Use the no form of this command to return to the default setting.
This command is available only on Catalyst 2950 LRE switches.
Syntax Description 10
100
Defaults
The default is 100 Mbps.
Command Modes
Interface configuration
Command History Release
12.1(11)YJ
Usage Guidelines
This command sets the speed only on an LRE link. To set the speed on a customer premises equipment
(CPE) Ethernet link, use the cpe speed interface configuration command. To set the speed of the Gigabit
Ethernet ports, use the speed interface configuration command.
Examples
This example shows how to set LRE port 1 to 100 Mbps:
Switch(config)# interface longreachehernet1/1
Switch(config-if)# local speed 100
You can verify your settings by entering the show running-config privileged EXEC command.
Related Commands Command
cpe duplex
cpe speed
duplex
local duplex
speed
Catalyst 2950 and Catalyst 2955 Switch Command Reference
2-172
local speed {10 | 100}
no local speed
Specify that the LRE port run at 10 Mbps.
Specify that the LRE port run at 100 Mbps.
Modification
This command was introduced.
Description
Specifies the duplex mode of CPE Ethernet ports.
Specifies the speed of CPE Ethernet ports.
Specifies the duplex mode of Gigabit Ethernet ports.
Specifies the duplex mode of operation for LRE ports.
Specifies the speed of Gigabit Ethernet ports.
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
OL-10102-01