Assigning A Profile To A Specific Lre Port; Assigning A Global Sequence To All Lre Ports - Cisco 2950G 24 - Catalyst Switch Software Configuration Manual

Chapter 10 Configuring LRE
Use the show controllers lre privileged EXEC commands to display the LRE link statistics and profile
information on the LRE ports. For information about these commands, refer to the switch command
reference.

Assigning a Profile to a Specific LRE Port

You can set profiles on a per-port basis. You can assign the same profile or different profiles to the LRE
ports on the switch. The default active profile on all LRE ports is LRE-10.
The switch resets the ports with the updated profile settings when changed.
Beginning in privileged EXEC mode, follow these steps to assign a profile to a specific LRE port:
Command
Step 1 configure terminal
Step 2
interface LRE-interface
Step 3
profile profile_name
Step 4 end
Step 5 show controllers lre profile details
Use the show controllers lre privileged EXEC command to display the LRE link statistics and profile
information on the LRE ports. For information about these commands, refer to the switch command
reference.

Assigning a Global Sequence to All LRE Ports

Global sequences are set on a switch-wide basis. If you assign a global sequence to the switch, it
over-rides any previously or subsequently set profiles. (For further information on sequence and profile
precendence, see
Changes to the global sequence settings are immediately put in effect, and the global mode automatically
becomes the active mode.
Beginning in privileged EXEC mode, follow these steps to assign a global sequence to the LRE ports:
Command
Step 1 configure terminal
Step 2
lre rate selection sequence sequence_name Enter the global sequence name. Select from the list in
Step 3
end
Step 4 show controllers lre status sequence
Use the show controllers lre status sequence details privileged EXEC commands to display the LRE
link statistics and sequence information on the LRE ports. For information about these commands, refer
to the switch command reference.
78-14982-01
Purpose
Enter global configuration mode.
Enter interface configuration mode, and enter the number of the LRE port to
be configured.
Enter the port profile name (select from the list in
Return to privileged EXEC mode.
Verify the change.
Guidelines for Using LRE Profiles, page
Purpose
Enter global configuration mode.
Return to privileged EXEC mode.
Verify the change.
Catalyst 2950 Desktop Switch Software Configuration Guide
Configuring LRE Ports
Table 10-1).
10-7.)
Table 10-2.
10-9