Time Program Starting; Time Program Stopping; Time Program Operation Examples - Hitachi CHROMASTER 5160 Instruction Manual

3.4.2 Time program starting

3.4.3 Time program stopping

3.4.4 Time program operation examples

(b) When the time program settings are completed, the 1
monitor screen reappears.
(7) Addition of steps
Press the INSERT key to add a step to the program during
step input. The step setting screen will appear, so make
the addition in the same procedure as described above.
However, the addition must be made within the time
entered at the final step.
Press the START key to start the time program.
Status indication on the 1
program is running), and the elapsed time is indicated at TIME.
The PROG. RUN LED lights up in blue.
<1st monitor screen>
TIME Ex Em
*** 250 350
Press the STOP key, then the time program under execution
st
stops and the 1 monitor screen returns.
(1) Setting of time program
Described next is the procedure for newly creating a time
program shown in the figure.
3 - 33
st
monitor screen becomes R (time
FL PROG LAMP
0.0 1 Xe
st
[R]