Hitachi CHROMASTER 5160 Instruction Manual page 718

5.2 System Cabling
In the Chromaster series, the module units are cabled by
plugging the e-Line cable into the e-Line connector at the rear
left of each unit.
Rear panel of
module unit
(1) Isocratic System/Low-pressure Gradient System
Chromaster
organizer
Chromaster 5410/ 5420/
5430/ 5450 detector
Chromaster 5310
column oven
Chromaster 5210
autosampler
Interface control
board
Chromaster 5110
pump
Appended Fig. 1-6 e-Line Cable Connection
Appended Table 1-3 Cables to be Used
e-Line cable 1) (50 cm)
e-Line cable 2) (80 cm)
APPENDIX 1 - 11
e-Line connector
Power connector
P/N 890-6105 (attached to each unit)
P/N 890-6107 (attached to autosampler
and interface control PC board)
e-Line cable 1)
e-Line cable 2)