Hitachi CHROMASTER 5160 Instruction Manual page 800

Needle : Aspirates a sample.
Arm : Move right to left (X direction), back and forth (Y
Leak sensor : Detects fluid leakage.
Injection port : A port into which the needle is inserted to
Sample loop : Stores samples.
IFC board
Thermostat power supply
(Depends on the optional)
Fig. 2-4
Wiring cover
Grounding terminal
Thermostat power supply (depend on the optional)
IFC board (option)
External input terminal
2 - 4
direction), and up and down (Z direction).
inject a sample into the sample loop.
External output terminal
WAIT OFF IN
START OUT
ALL END OUT
Grounding terminal
Rear View
: Removal of the left wiring cover (as
seen from the front) gives access to the
e-Line connector for connecting the
units of Chromaster series and the
power connector.
: Grounds the autosampler.
: Used for the optional thermostat.
: An interface control board (option)
required for connecting the PC
(chromatography data station), the GUI
controller and HPLC system.
: One input terminal and two output
terminals. Refer to the following table.
Wiring cover