Hitachi CHROMASTER 5160 Instruction Manual page 862

(a) Sequential parameter
The sequential parameter is settable in the following
procedure.
UTILITY (SEQ=1, RACK=2, WASH PARAM=3,
1 OTHERS=4)
1 ENT
SEQ PARAM (START STEP=1, ALL END=2,
1 OPERATION=3, INJ TIMING=4)
1 ENT
START STEP (1-100)
1
Input the start step (for start from a halfway step in a
sequential program).
The set value of start step will return to 1 once the
NOTE:
autosampler has been started by pressing the
START key.
Monitor screen reappears.
2 ENT
ALL END OUT (YES=1, NO=0)
1
At the end of a sequential program, the ALL END signal can
be output. This signal is usable for control of other module
connected.
For output of the ALL END signal, input "1" (YES) or "0"
(NO) for avoiding the output.
0 ENT
Monitor screen reappears.
(to be continued)
3 - 18