Hitachi CHROMASTER 5160 Instruction Manual page 619

Caution on Disposal of Instrument
Although at present the instrument does not use materials that would directly cause
environmental disruption, the environmental protection laws and regulations may be revised or
amended. When planning to dispose of the instrument, therefore, be sure to check the latest
issues of the relevant laws and regulations or consult our sales representative.
Disposal of This Instrument and Its Parts
In the present design, this instrument does not use materials that would directly cause
environmental harm. Note, however, that the environmental protection laws and regulations
may be revised or amended. Therefore, be sure to consult with your local Hitachi
High-Technologies sales or service representative when planning disposal of this instrument or
its parts and accessories.
When discarding or recycling the used PC, it is the user's responsibility to delete all data from
the hard drive.
When discarding the chargeable battery mounted on the PC, refer waste disposal treatment
servicing to an authorized waste collection agent, or send the battery for recycling after
providing insulation on its positive and negative terminals with adhesive vinyl tape or the like.
Precautions on CE Conformity Marking
In consideration of use in the European countries, this instrument bears the CE mark indicating
the conformity to the requirements mentioned below.
Electromagnetic Compatibility Requirement
This instrument is designed to satisfy the European Norm EN61326-1 (2006) for the CE
conformity marking through conformity to the EMC Directive 2004/108/EC.
This instrument is classified as Class A of EN61326-1. So, this instrument must not be used in
domestic establishments nor in establishments directly connected to a low voltage power
supply network which supplies buildings used for domestic purpose.
And this instrument is also designed to comply with table 1 "Basic immunity test requirements"
in the above European Norms. If the instrument is used near an intense electromagnetic
source, however, interfering noise may be given to the instrument to cause an adverse effect
on its performance or functionality.
Safety Requirement
This instrument is also designed to satisfy the European Norm EN61010-1 (2001) for the CE
conformity marking through conformity to the LVD Directive 2006/95/EC.
This instrument is requested to be used in a suitable environment and grounded appropriately.
IMPORTANT - 5