Spindle Parameter Sets (Nck/Servo) - Siemens SINUMERIK 840C Installation Instructions Manual

10.94

Spindle parameter sets (NCK/SERVO)

8 parameter sets have been provided to date for spindles. A mechanical gear stage is
generally linked to these parameter sets, but is not a mandatory requirement.
Parameter
Maximum speed
Minimum speed
Accel. time pos. const.
w/o position controller
Creep speed
Servo gain factor
Accel. time pos. const.
with position controller
(PaSe=parameter set)
The switchover is implemented by means of the "Actual gear stage" control bits in the
cyclical, spindle-specific PLC interface (DB 31, DR K + 1, bits 0 - 2), i.e. the user can directly
select the active parameters via the PLC program.
In addition, the user also has an automatic gear stage selection function at his disposal which
works in the following way:
Speed ranges are defined by means of MD 403* - 410* and MD 411* - 418*. When a speed is
programmed by means of an S value, a setpoint gear stage (SGS) is output to the PLC which
is capable of evaluating it. After execution of the gear change, the setpoint gear stage can be
acknowledged through setting of the actual gear stage (AGS) and cancellation of the "Change
gear" signal (DB 31, DR K, bit 7).
© Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
More user manuals on
Gear-stage-depend. parameters
1stPaSe
403*
411*
419*
427*
435*
478*
ManualsBase.com
12.27.1 Parameter set switchover (up to SW 3)
4thPaSe 5thPaSe 6thPaSe 7thPaSe 8thPaSe
2ndPaSe 3rdPaSe
MD
404* 405* 406*
412* 413* 414*
420* 421* 422*
428* 429* 430*
436* 437* 438*
479* 480* 481*
6FC5197- AA50
12 Functional Descriptions
Effective in: SERVO /
NCK
407* 408* 409* 410*
415* 416* 417* 418*
423* 424* 425* 426*
431* 432* 433* 434*
439* 440* 441* 442*
482* 483* 484* 485*
12–271