Samsung iDCS 500 Programming Manual page 73

iDCS 500
TECHNICAL MANUAL
BEGN DGT DSP :ON
ONE TCH FACC: ON
SGR ALL OUT :ON
CHAIN FWD :ON
TRK MONITER :ON
VoIP MFRALOC :OFF
NTWK AUTOTMR:ON
PERI UCD SIO:
REDIAL REVW:OFF
PROG. 2 ALERT: OFF
VOIP VIR RBT
PRESET BUSY
SMDR AUT2ACC
MMC: 210
When ON and an outside call is made via speed dial or LNR
where more than 11 digits are dialed, then only the first 11
digits dialed are shown on the keyphone display. When OFF,
the last 11 digits are displayed.
When ON, then a station may enter an account code using a
one touch account code (ACC) key. When OFF, then a
station must enter an account code by dialing via dial-pad
before making an outside call.
This option, when on, allows all members to log out of a
station group.
When ON and a call is directed to a station that may be
forwarded to another station that is call forwarded to a VMAA,
then the caller will be directed to the last station's mailbox it
reached. When OFF, then the caller will be directed to the
first station's mailbox instead of the last.
When set to ON, a barging party maintains the trunk
connection, when the barged station goes on hook. When set
to OFF, and the barged station goes on hook, all parties are
disconnected.
When set to ON, a DTMF receiver is assigned for VoIP
tandem calling when a VoIP incoming trunk is connected to a
VoIP outgoing trunk. Note: Except when H.245 signal mode
is being used.
This option only affects systems with LE software and
controls whether an intercom call across the network link will
have the auto timer come on when the call is received.
When this option is set to ON the PERI UCD date is sent to
the UCD port type of SIO port service, instead of the PERI
UCD port type.
When set to ON, this option will allow the user to review the
last number dialed before dialing.
Not for US use.
This option is used to provide a virtual ringback tone on
VOIP calls when set to ON. If set to OFF, ringback tone must
be provided by the far end.
When set to ON this option makes the preset forward no
answer setting in MMC 316 act as forward on BUSY/NO
ANSWER.
When this option is set to ON, the Authorization Code will be
printed out in the Account Code field (up to 10 digits).
PROGRAMMING
PART 2 SEPTEMBER 2003
HOME
PAGE
Table of
Contents
HELP