Samsung iDCS 500 Programming Manual page 188

iDCS 500
TECHNICAL MANUAL
AUTO REDIAL INT
AUTO REDIAL RLS
CALLBACK NO ANS
CAMP ON RECALL
CID DISPLAY TIME
CID MSG RECEIVE
C.O.-C.O. DISCONNECT This timer monitors the duration of an unsupervised
CONFIRM TONE TIME
CRD TONE INT TM
DIAL PASS TIME
DISA DTMF DETECT
DISA DISCONNECT
DISA LOCK OUT TIMER This timer controls the duration of time a DISA call is not
DISA PASS CHECK
MMC: 501
This timer controls the time between attempts after RETRY
dialing is set on a station.
This timer controls the duration of a Ring No Answer
condition on a retry number dialed before the auto redial is
automatically canceled.
This timer controls the time before the callback is
automatically canceled when a callback detects Ring No
Answer.
This timer controls the duration of time a camped-on call will
stay at a destination before recalling to the transferring
station.
The amount of time that the Caller ID information remains on
the keyset's display.
The amount of time that the system will allow a valid
message from the C.O.
conference; when it expires, both trunks are disconnected.
The tone heard when a feature is activated or deactivated.
This is the call record tone interval time. An entry other than
zero will cause a tone to be heard by all the parties in a
recorded conversation. The range for the tone is 001 (every
second) to 255 (every 255 seconds). A value of 000 means
no tone. Requires SVMi-8 card.
This timer monitors the duration of time before connecting
the transmit of the keyset to the trunk side of an outgoing
call.
This timer sets the time duration that DTMF can be received
on a DISA line.
This timer controls the maximum duration of a DISA call.
allowed to be made after the DISA error counter has expired
(MMC 500).
This timer defines the time period before the system clears
the incorrect passcode counter.
PROGRAMMING
PART 2 SEPTEMBER 2003
HOME
PAGE
Table of
Contents
HELP