Samsung iDCS 500 Programming Manual page 56

iDCS 500
TECHNICAL MANUAL
MMC: 200
DESCRIPTION:
Used to open (enable) and close (disable) customer-level programming. If
programming is not opened and an attempt is made to access a system MMC, the
error message [NOT PERMIT] will be displayed. A four digit passcode is required to
access this MMC. Each digit can be 0-9. When opened, this MMC enables access
to all MMCs allowed in MMC 802 Customer Access MMC Number.
PROGRAM KEYS
UP & DOWN Select open or closed
KEYPAD Used to enter passcode
SPK Save data and advance to next MMC
TRSF Exit Programming
ACTION
1. Press TRSF 200
Display shows
2. Enter passcode
Correct code shows
Incorrect code shows
3. Press UP or DOWN arrow key to select
ENABLE or DISABLE and press RIGHT soft
key
OR
Dial 1 for ENABLE or 0 for DISABLE
4. Press SPK to advance to MMC entry level
and press UP or DOWN key to select MMC
OR
Enter MMC number and press RIGHT soft
key to enter MMC
5. Press TRSF key to exit
OPEN CUSTOMER PROGRAMMING
ENABLE CUS.PROG.
PASSCODE:
ENABLE CUS.PROG.
PASSCODE:
ENABLE CUS.PROG.
DISABLE
ENABLE CUS.PROG.
PASSWORD ERROR
ENABLE CUS.PROG.
ENABLE
212:ALARM RING
SELECT PROG. ID
PROGRAMMING
PART 2 AUGUST 2001
DISPLAY
HOME
PAGE
Table of
Contents
HELP