Samsung iDCS 500 Programming Manual page 171

idcs 500
TECHNICAL MANUAL
MMC: 426
DESCRIPTION:
This MMC is used by the technician to assign the Service Profile IDentifiers (SPIDs)
and the Directory Numbers (DNs) to the Basic Rate Interface (BRI) circuits on the
P4BRI card. It assigns an incoming MSN call to up to six ring plan station or station
group destinations. Also, it provides a call waiting option, if needed, so that a
second incoming MSN call can be received. There are two MSN entries for each
trunk and each can have up to six ring plan destinations, a call waiting option, and
an accept/reject option.
NOTE: The options in this MMC apply to BOTH channels of a BRI circuit. If you
change the settings for one channel the settings for the other channel on
that BRI will automatically change as well.
OPTION DESCRIPTION
SPID This is the Service Profile IDentifier number which is used to specify the
type of service (e.g., incoming, outgoing, bothway) and service
attributes (e.g., voice only, data only, voice and data), etc. available on
this facility.
DN This is a CO number associated with this circuit. Each circuit can have
up to two CO numbers of up to ten digits in length.
1-6 These numbers correspond to the six ring plan destinations (maximum)
for this MSN. The destinations can be either stations or station groups.
CW Call Waiting (i.e., if the destination is busy will the call camp on or give
an audible BUSY tone signal).
OPT ACEPT - this setting will allow incoming calls to follow the previously
entered ring plan destination data
RJECT - this option will reject all incoming calls to this circuit.
PROGRAMMING
PART 2 JANUARY 2001
BRI SPID / DN
HOME
PAGE
Table of
Contents
HELP