Samsung iDCS 500 Programming Manual page 27

iDCS 500
TECHNICAL MANUAL
MMC: 105
DESCRIPTION:
Allows the system administrator or technician to program the personal speed dial
locations assigned to a station. This must be done for single line telephones
because these stations cannot access programming. Each station may have up to
50 locations or bins assigned to it in MMC 606 Assign Speed Block. The speed dial
bins are numbered 00 ~49. Each speed dial number consists of a trunk or trunk
group access code followed by a separator and up to 24 digits to be dialed. These
dialed digits may consist of 0 ~9, ✱ and #. If the system recognizes a valid trunk or
trunk group access number, it will automatically insert the separator.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
HOLD Used to clear previous entry
B Used to insert a flash code "F"
C Used to insert a pause code "P"
D Used to insert a pulse/tone conversion code "C"
E Used to mask/unmask following digits (shows as "[" or "]")
F Used to enter name for speed dial bin (see MMC 106)
ACTION
1. Press TRSF 105
Display shows
2. Dial station number (e.g. 205)
OR
Press UP or DOWN to select station and
press RIGHT soft key to move cursor
If selected station has no speed dial bins,
the display will be as shown and a new
station may be selected.
PART 2 NOVEMBER 2001
STATION SPEED DIAL
DISPLAY
[201] SPEED DIAL
00 :
[205] SPEED DIAL
00 :
[205] SPEED DIAL
SPDBLK NOT EXIST
HOME
PAGE
PROGRAMMING
Table of
Contents
HELP