Samsung iDCS 500 Programming Manual page 187

iDCS 500
TECHNICAL MANUAL
PERI UCD REPORT
POWER DOWN TIME
RECALL DISCONECT
RECALL WAIT TIME
ROUTE OPTIMIZE
SMDR START/DP
SMDR START/DTMF
SYS HOLD RECALL
TRANSFER RECALL
TSW CONN. DEL
UCDS AUDIO ALARM
UCDS VISUAL ALAM
VOICE DIAL DELAY
*Also used for wake-up calls.
AA INT DGT TIME
AA NO ACT TIME
ALARM TIMER
ALERT TONE TIMER
ALM REM INTERVAL
ALM REM RING OFF
ATT RECALL TIME
MMC: 501
TIMER DESCRIPTIONS
When the AA card is installed, this timer determines the
interdigit time for AA call processing. If this timer expires
before valid digits are received by the AA card, the call will
be routed to the AA invalid digits destination.
When the AA card is installed, this timer determines the time
that the AA card will wait for a first digit for AA call
processing. If this timer expires before a digit is received, the
call will be routed to the AA no action destination.
This is the time the system alarm key will start ringing after
the alarm key has been silenced.
This timer sets the duration of the attention tone preceding a
call to a keyset in the Voice Announce or Auto Answer
mode. This tone will also precede a forced Auto Answer call.
This timer controls the time length between ring attempts at
a station when alarm reminder is set. (Also used for wake-up
calls).
This timer controls the length of the ring cycle duration when
alarm reminder is set at a station. (Also used for wake-up
calls).
This is the length of time a transfer recall will ring at a station
before recalling the operator.
PART 2 SEPTEMBER 2003
05 SEC
2000 MS
002 MIN
15 SEC
10 SEC
30 SEC
15 SEC
45 SEC
20 SEC
00 SEC
0 SEC
0 SEC
8 SEC
PROGRAMMING
03-99 SEC
1000–9000 MS
1–250 SEC
000–250 SEC
0–250 SEC
1–250 SEC
1–250 SEC
0–250 SEC
0–250 SEC
00–10 SEC
0–990 SEC
0–990 SEC
5–15 SEC
HOME
PAGE
Table of
Contents
HELP