Samsung iDCS 500 Programming Manual page 371

iDCS 500
TECHNICAL MANUAL
MMC: 806
DESCRIPTION:
Allows the preprogramming of a card slot for a specific board type. A board inserted
into a iDCS 500 system will not be recognized by the system until it is ENABLED
using this MMC. Cards installed using MMC 806 will NOT be assigned in the system
numbering plan. You must then use MMC 724 to assign the desired directory
numbers to extensions, trunks, AA, ports or miscellaneous functions. This MMC
also shows which PSU is powering the card selected.
NOTE1: If a card is removed and a different type card is inserted and this MMC is
performed, the memory associated with that card (i.e. key programming, etc.) will
be erased.
NOTE 2: If a second PSU is required and is not available to support the added
card(s) this MMC will provide an error NO POWER and will not allow card install. A
second PSU must be installed in the cabinet the card is to be installed in.
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPK
ACTION
1. Press TRSF 806
Display shows
2. Press UP or DOWN key to make selection
(i.e. Cabinet 1) and press RIGHT soft key
To select which slot to address press UP or
DOWN key to make selection
OR
Use the dial pad to make a selection (i.e.
Slot 6) and press RIGHT soft key
Press UP or DOWN key to make selection or
use the DIAL to select (1 = yes 0 = no).
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next MMC
PART 2 NOVEMBER 2001
CARD PRE-INSTALL
DISPLAY
C:1 – S:1 P:1
16DLI-> 16DLI
C:1 – S:1 P:1
16DLI-> 16DLI
C:1 – S:1 P:B
16DLI-> 16DLI
C:1 – S:6 P:N
NONE -> 16DLI
C:1 – S:6 P:N
RESET CARD?
HOME
PAGE
PROGRAMMING
Table of
Contents
HELP
YES