Samsung iDCS 500 Programming Manual page 72

iDCS 500
TECHNICAL MANUAL
DISA MOH :OFF
TRANSFER MOH :OFF
DID BSY ROUT :OFF
ALARM MOH: OFF
RECALL PICKUP :ON
ICM EXT FWD :OFF
SEC 2 BOSS AA :ON
DID ERR TONE :OFF
TRSF CANCEL :OFF
ISDN PROGCON:OFF
DSS KEY DPU :OFF
MMC: 210
When this option is turned ON outside parties will hear trunk
MOH instead of dial tone from the time the system answers a
DISA trunk until the caller dials a digit. System default is
OFF.
When this option is turned ON outside parties will hear trunk
MOH instead of ring back tone from the time a transfer is
completed until the call is answered by an internal party.
System default is OFF.
When this option is turned on a DID call directed to a busy
station will reroute to the operator if camp on is set to OFF in
MMC 714. If the option is set to ON the call will re route to the
destination in MMC 406 for that trunk.
When ON allows stations to hear MOH after answering an
alarm reminder call.
When this option is turned on a call recalling to a station can
be picked up using Direct Call Pickup, Pickup Group and My
Group features. This applies to held calls recalling and
transferred calls recalling to a station.
When this option is on call forward external is allowed when
intercom calls are placed to a station that has Call Forward
External programmed and set.
This option can stop calls from the secretary to the boss from
being auto answered by the boss station. The default setting
is ON allowing auto answer when a secretary calls a boss via
an assigned boss key.
This option was added to provide error tone when an invalid
DID number is received. The iDCS 500 error tone should not
be sent to the public network in the USA.
When turned OFF a single line phone will be able to handle 2
calls simultaneously. Using the hook-flash to toggle between
them. When turned ON a single line telephone will be able to
nd
connect to the 2 call, but pressing the h/f will not toggle
between the two calls it will disconnect the 2
reconnect the single line telephone to the first call.
This option, when ON, determines if the system will wait for
an answer signal before allowing DTMF to be sent on an
ISDN circuit. (L Version Only)
When set to ON, the station can make a directed call pickup,
by pressing the flashing DSS key of the ringing station.
PROGRAMMING
PART 2 SEPTEMBER 2003
nd
call and
HOME
PAGE
Table of
Contents
HELP