Samsung iDCS 500 Programming Manual page 399

iDCS 500
TECHNICAL MANUAL
MMC: 834
DESCRIPTION:
This MMC provides various VoIP support options. The options set in this MMC are
ITM3 system wide.
NOTE: Programming MUST be exited before changes to the ITM3 take effect.
• H.323 FAST START SETUP: Enables or disables the H.323 Fast Start call
method.
• GATEWAY CALL ID: This is a numeric entry that identifies the iDCS 500 system
via an ITM3 connection. The maximum entry is 4 digits.
• BILLING TYPE: STANDARD (Used in USA ) This entry cannot be changed.
• CALLER ID TYPE: This option controls the calling party identification type.
There are 3 possible selections. ANI shows the calling station number when the
call is an ITM3 to ITM3 (CLID Tables must be used). IP shows the calling ITM3 IP
address. Gateway ID (GWID) which is a 4 digit preprogrammed ID of the ITM
card.
• INCOMING CHANNEL SELECTION: This option selects whether the incoming
channel is Sequential or Distributed.
• DTMF GENERATION: This option allows 4 different transport types of DTMF.
Inband, Q931, H.245 Signal, H.245 Numeric are the available selections.
• FAX SIGNAL TYPE: This option selects the facsimile standard to use when
transporting facsimiles via the ITM3. Selections are T.38 or the proprietary
Samsung formats. Default is the T.38 facsimile standard.
• SWITCH TO H.245: This option enables switching to the H.245 protocol at the
time of Fast Start
• DEFAULT DIL NO: This allows programming of the default DIL number
destination when an incoming call is from a destination that is originating a call
via an IP address (IE. Microsoft NetMeeting)
• SNMP SERVER IP: This allows entry of the SNMP server IP address when
connected to network management equipment.
PROGRAMMING
PART 2 SEPTEMBER 2003
VoIP OPTION
HOME
PAGE
Table of
Contents
HELP