Suzuki Grand Vitara 2011 Manual page 1183

DTC
(displayed
Diagnostic Items
on SUZUKI
scan tool)
ESP® (ABS) control
C1057 module power supply circuit
failure *3
Pump motor and/or motor
C1061
circuit failure
Solenoid valve power
C1063
supply driver circuit failure
ESP® (ABS) control
C1071
module internal defect
Lost communication with
C1073 yaw rate / G sensor
assembly
Steering angle sensor
C1075
calibration incomplete *4
Master cylinder pressure
C1076 sensor calibration
incomplete
Longitudinal G sensor in
yaw rate / G sensor
C1077
assembly calibration
incomplete
Lateral G sensor in yaw rate
C1078 / G sensor assembly
calibration incomplete
ECM detect rolling counter
C1090 failure from ESP® control
module
ECM data in CAN line
C1091
failure
TCM data in CAN line
C1092
failure
4WD control module data in
C1093
CAN line failure
Control module
U1073
communication bus off
Lost communication with
U1100
ECM (reception error)
Lost communication with
U1101
TCM (reception error)
Lost communication with
U1126 steering angle sensor
(reception error)
Lost communication with
U1139 4WD control module
(reception error)
Lost communication with
U1140
BCM (reception error)
Detecting condition (DTC will be
set when detecting)
ESP® (ABS) control module power
supply voltage is too high.
ESP® (ABS) control module power
supply voltage is too low.
Defective pump motor and/or motor
power supply voltage is too low.
Mismatching solenoid output and
solenoid monitor is detected.
ESP® (ABS) control module internal
defect is detected.
CAN line communication error in
ESP® control module and yaw rate /
G sensor assembly is detected.
Missing steering angle sensor
calibration point data is detected.
Master cylinder pressure sensor
calibration is incompleted.
Longitudinal G sensor in yaw rate / G
sensor assembly calibration is
incompleted. (for 4WD vehicle)
Lateral G sensor in yaw rate / G
sensor assembly calibration is
incompleted.
ESP® control module rolling counter
failure is detected by ECM.
ECM sent invalid signal to ESP®
control module.
TCM sent invalid signal to ESP®
control module. (for A/T model)
4WD control module sent invalid
signal to ESP® control module. (if
equipped 4WD control module)
Transmission error that is
inconsistent between transmission
data and transmission monitor (CAN
bus monitor) data is detected more
than 7 times continuously.
ECM message data is missing from
CAN communication.
TCM message data is missing from
CAN communication. (for A/T model)
Steering angle sensor message data
is missing from CAN communication.
4WD control module message data
is missing from CAN communication.
(if equipped 4WD control module)
BCM message data is missing from
CAN communication.
Electronic Stability Program:
ABS EBD
warning warning
light light
*5
—
*2 —
— —
— —
—
— —
— —
— —
— —
— —
4F-15
ESP®
warning
light
—