Air Bag" Warning Lamp Does Not Come - Suzuki Grand Vitara 2011 Manual

8B-21 Air Bag System:
Step
5 1) Disconnect combination meter connector "G28" referring
to "Combination Meter Removal and Installation in
Section 9C".
2) Check proper connection to combination meter at "YEL/
BLK" terminal for "AIR BAG" warning lamp and to SDM
at terminal "G47-18" or "G46-7".
3) If OK, then check resistance between "YEL/BLK" wire
terminal of combination meter connector "G28" and
"G47-18" terminal [A] or "G46-7" terminal [B] of SDM
connector.
Special tool
(A): 09932–76010
[A]
"G47-18"
[B]
"G46-7"
Ω
Is resistance 1 or less?
NOTE
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components and ensure all components are properly mounted.
• Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.
"AIR BAG" Warning Lamp Does Not Come ON
Wiring Diagram
Refer to ""AIR BAG" Warning Lamp Comes ON Steady".
CAUTION
!
Be sure to observe instructions under CAUTION in "Air Bag Diagnostic System Check Flow".
Flow Test Description
Step 1: Check combination meter power feed circuit.
Step 2: Check "AIR BAG" warning lamp circuit.
Action
(A)
I5JB0A820019-01
Yes
Substitute a known-
good SDM and recheck.
If "AIR BAG" warning
lamp remain lighting,
replace combination
meter.
No
"YEL/BLK" wire
(between combination
meter and SDM
connector) open or
short to ground.
S6JB0A8204008