Table of Contents
Advertisement
6B-12 Steering Wheel and Column:
Installation
1) Position oblong hole of steering shaft (2) in the
center of hole in steering column assembly (1).
1
2) Turn ignition key to ACC or ON position and install
steering lock assembly onto column.
3) Now turn ignition key to LOCK position and pull it
out.
4) Align hub on lock with oblong hole of steering shaft
and rotate shaft to assure that steering shaft is
locked.
5) Tighten new bolts until head of each bolt is broken
off.
6) Turn ignition key to ACC or ON position and check to
be sure that steering shaft rotates smoothly. Also
check for lock operation.
7) Install steering column. Refer to "Steering Column
Assembly Removal and Installation".
8) (Keyless start model)
If steering lock assembly has replaced, after
completing installation, register steering lock unit ID
code to keyless start control module as following.
• Immobilizer model:
Register ignition key transponder code in ECM
referring to "Registration of the Ignition Key: For
Petrol Engine Model in Section 10C" or
"Registration of the Ignition Key: For Diesel
Engine Model in Section 10C".
• Non immobilizer model:
Register steering lock unit ID code in keyless start
control module referring to "Keyless Start
Registration in Section 10E".
2
I5JB0A620028-01
I5JB0A620029-01
Adjustable Steering Column Release Lever
Inspection
Check to make sure that the followings:
• Steering column (1) moves smoothly when adjustable
steering column release lever is at upper position (2)
(i.e., steering column is not locked).
• Steering column (1) is fixed securely when adjustable
steering column release lever is at lower position (3)
(i.e., steering column is locked).
Steering Upper Shaft Assembly Removal and
Installation
CAUTION
!
Never turn steering wheel while steering
upper shaft assembly is removed.
Should it have been turned and contact coil
cable assembly have got out of its centered
position, it needs to be centered again. Also,
turning steering wheel more than about two
and a half turns will break contact coil cable
assembly.
Removal
1) Turn steering wheel so that vehicle's front tires are at
straight-ahead position.
2) Turn ignition switch to LOCK position and remove
key.
3) Remove steering column assembly from vehicle
referring to "Steering Column Assembly Removal
and Installation".
S6JB0A6206012
1
2
3
I5JB0A620030-01
S6JB0A6206013
Advertisement
Chapters
Table of Contents
