Repair Instructions; Transfer Oil Level Check; Transfer Oil Change - Suzuki Grand Vitara 2011 Manual

3C-55 Transfer: Motor-Shift Type (Transfer with Shift Actuator)

Transfer Oil Level Check

1) Lift up vehicle and check oil leakage.
2) Remove oil level/filler plug (1) and check oil level is
between 0 and 10 mm (0 and 0.394 in.) from the
lower end of oil level / filler plug hole (2).
If oil level is not in the range, add specified oil up to
plug hole.
"a". 0 – 10 mm (0 – 0.394 in.)

Transfer Oil Change

1) Before changing oil, be sure to stop engine and lift
vehicle horizontally.
2) Check leakage.
If leakage exists, correct it.
NOTE
Whenever vehicle is hoisted for any other
service work than oil change, also be sure to
check for oil leakage.
3) Remove oil filler plug (2).
4) Remove drain plug (1), and drain oil.
5) Apply sealant to thread of drain plug (1), and tighten
it to specified torque.
"A": Sealant 99000–31260 (SUZUKI Bond
No.1217G)
Tightening torque
Transfer oil drain plug (a): 23 N·m (2.3 kgf-m,
17.0 lb-ft)

Repair Instructions

6) Pour new specified oil up to lower end of oil level /
S6JB0A3316001
filler plug hole (3).
NOTE
It is highly recommended to use API GL-5
80W-90 gear oil.
Transfer oil specification
: API GL-4 (For SAE classification, refer to
viscosity chart [A] in figure.)
Transfer oil capacity (Motor-Shift Type)
Reference: 1.5 liters (3.2/2.6 US/lmp. pt)
7) Apply sealant to thread of level / filler plug, and then
tighten it to specified torque.
"A": Sealant 99000–31260 (SUZUKI Bond
No.1217G)
Tightening torque
Transfer oil level / filler plug (b): 23 N·m (2.3 kgf-
m, 17.0 lb-ft)
I5JB0A331001-02
S6JB0A3316002
"a". 0 – 10 mm (0 – 0.394 in.)
I5JB0A331002-03