11) Remove needle bearing (1), snap ring (2), washer
(3) and shim(s) (4) from rear output shaft (5).
5
12) Remove reduction shift sleeve (1), center differential
and low gear from rear output shaft (2).
2
13) Remove needle bearings (1), front drive shaft (2)
and thrust needle bearing (4) from rear output shaft
(3).
3
1
14) Remove differential lock clutch sleeve (1) from rear
output shaft (2).
2
Transfer: Motor-Shift Type (Transfer with Shift Actuator) 3C-62
1
2
3
4
I5JB0A331019-01
1
I5JB0A331020-02
1
2
4
I5JB0A331021-01
1
I5JB0A331022-01
15) Remove front drive sprocket bush (1) from rear
output shaft (2).
16) Take out front drive sprocket (1), front output shaft
assembly (2), drive chain (3) and needle bearing (4)
from rear case (5) all at once.
1
4
17) Remove snap ring (1), and then remove rear output
shaft assembly (2) from rear case (3).
1
18) Remove rear oil seal (1) from rear case (2) using flat
end rod or the like, if necessary.
1
2
I5JB0A331023-01
2
5
3
I5JB0A331024-01
2
3
I5JB0A331025-01
1
2
I5JB0A331026-01