Suzuki Grand Vitara 2011 Manual page 1356

5A-131 Automatic Transmission/Transaxle:
Assembly
Assemble components by reversing disassembly
procedure and noting the following points.
• Refer to "Planetary Gears and Output Shaft
Components" when installing each component.
• Check seal ring for damage before installation and
replace if damaged.
• Install planetary sun gear as shown in the figure.
NOTE
A is longer than B.
• Fit retaining rings into groove securely.
• Install one-way clutch as shown in the figure.
1. Front planetary gear side
• Install reverse brake reaction plate (2) to front
planetary gear (1).
With reverse brake reaction plate (2) fixed stationary,
turn front planetary gear (1) clockwise to check that it
locks and then counterclockwise to check that it turns
smoothly.
[A]: Rotates
[B]: Locks
Planetary Gears and Output Shaft Inspection
• Check that sliding surface of discs and plate are not
worn or burnt. if necessary, replace them.
NOTE
• If disc lining is exfoliated, discolored or
worn hardly, replace all discs.
• If only a part of printed numbers is
corroded, replace all discs.
• Before assembling new discs, soak them
in A/T fluid for at least 15 minutes.
I5JB0A510155-01
• Measure inside diameter of output shaft bushing. If
inside diameter exceeds limit, replace output shaft.
Output shaft bushing inside diameter standard
18.001 – 18.026 mm (0.7087 – 0.7097 in.)
IYSQ01510193-01
IYSQ01510194-01
S6JB0A5106050
I4JA01512210-01
I5JB0A510126-01