Thermal Switch On-Vehicle Inspection For; Thermal Switch Removal And Installation For M16 Engine Model - Suzuki Grand Vitara 2011 Manual

4) Install armature plate (1).
5) Using special tool (A), tighten new armature plate
bolt (2) to specified torque.
Tightening torque
Armature plate bolt (a): 21 N·m (2.1 kgf-m, 15.5
lb-ft)
Special tool
(A): 09991–06310
1, (a)
2
6) Adjust clearance between armature plate (1) and
magnet clutch pulley by putting shim(s) on
compressor shaft. To measure the clearance,
perform the following steps.
a) Put compressor in a vise.
b) Set dial gauge on magnet clutch plate, and then
adjust its pointer at 0.
c) Connect battery positive terminal (+) to magnet
clutch coil lead wire.
d) Connect battery negative terminal (–) to
compressor body assembly. (At this point,
armature plate and magnet clutch pulley (2) are
kept in contact.)
e) Disconnect battery negative terminal (–) to
compressor body assembly. (At this point,
armature plate and magnet clutch pulley (2) are
not in contact.)
f) Read stroke of armature plate from dial gauge by
performing Step d) and e) repeatedly. (Stroke of
armature plate is clearance between armature
plate and magnet clutch pulley (2).)
Standard clearance between armature plate and
magnet clutch
"a": 0.3 – 0.6 mm (0.012 – 0.024 in.)
1
"a"
2
(A)
I5JB0B720019-01
1
2
I5JB0A720078-02
Air Conditioning System:
7) Install compressor to vehicle referring to
"Compressor Assembly Removal and Installation
(F9Q Engine Model)".
Thermal Switch On-Vehicle Inspection for M16
Engine Model
Measured thermal switch for resistance at 20 °C (68 °F)
Thermal switch resistance
Standard: Approx. 50 or less mΩ (DC 12 V, 5 A)
Thermal Switch Removal and Installation for
M16 Engine Model
Removal
1) Disconnect negative (–) cable from battery.
2) Disconnect thermal switch connectors.
3) Remove thermal switch (1) from compressor
assembly (2) using flat head (3).
3
7B-94
S6JB0A7206042
I5JB0A720079-01
S6JB0A7206043
1
2
I5JB0A720080-01