Magnet Clutch Removal And Installation (F9Q Engine Model) - Suzuki Grand Vitara 2011 Manual

6) Adjust clearance between armature plate (1) and
magnet clutch pulley by putting shim(s) on
compressor shaft. To measure the clearance,
perform the following steps.
a) Put compressor in a vise.
b) Set dial gauge on magnet clutch plate, and then
adjust its pointer at 0.
c) Connect battery positive terminal (+) to magnet
clutch coil lead wire.
d) Connect battery negative terminal (–) to
compressor body assembly. (At this point,
armature plate and magnet clutch pulley (2) are
kept in contact.)
e) Disconnect battery negative terminal (–) to
compressor body assembly. (At this point,
armature plate and magnet clutch pulley (2) are
not in contact.)
f) Read stroke of armature plate from dial gauge by
performing Step d) and e) repeatedly. (Stroke of
armature plate is clearance between armature
plate and magnet clutch pulley (2).)
Standard clearance between armature plate and
magnet clutch
"a": 0.3 – 0.6 mm (0.012 – 0.024 in.)
1
"a"
2
7) Install compressor to vehicle referring to
"Compressor Assembly Removal and Installation for
J20 Engine Model".
1
2
I5JB0A720078-02
Air Conditioning System:
Magnet Clutch Removal and Installation (F9Q
Engine Model)
Removal
1) Remove compressor from vehicle referring to
"Compressor Assembly Removal and Installation
(F9Q Engine Model)".
2) Fix armature plate (1) with special tool (A) and
remove armature plate bolt.
Special tool
(A): 09991–06310
NOTE
Do not reuse armature plate bolt.
1
3) Remove armature plate.
4) Remove shim(s) from shaft.
5) Using special tool (A), remove snap ring (1).
Special tool
(A): 09900–06107
(A)
7B-92
S6JB0A7206052
2
(A)
I5JB0A720071-01
1
I5JB0A720072-01