Suzuki Grand Vitara 2011 Manual page 914

2C-21 Rear Suspension:
Installation
1) Install rear suspension frame stiffeners (1) and
dynamic damper (2) to rear suspension frame (3), if
removed.
Tightening torque
Rear suspension frame stiffener bolt (a): 50 N·m
(5.0 kgf-m, 36.5 lb-ft)
Dynamic damper bolt (b): 50 N·m (5.0 kgf-m,
36.5 lb-ft)
3
1
(a)
2) Remounting rear differential to rear suspension fame
referring to "Rear Differential Unit Components: Rear
in Section 3B".
3) Support rear suspension frame with rear differential
by using mission jack, and jack up it.
4) Install rear suspension frame (3) to vehicle body and
tighten rear suspension frame mount bolts (1) with
washer (2) to specified torque.
CAUTION
!
If suspension frame mount bolts are reused,
apply engine oil to thread, bearing and trunk
surface.
Tightening torque
Rear suspension frame mount bolt (a): 135 N·m
(13.5 kgf-m, 98.0 lb-ft)
2
1,(a)
(b)
2
1
I6JB0A230006-01
2
3
1,(a)
I5JB0A230051-02
5) Connect rear height sensor connector (3) and rear
height sensor harness clamp (4) (if equipped) for left
side.
6) Tighten wheel sensor bolt (1) to specified torque and
then connect wheel speed sensor harness clamp
(2).
Tightening torque
Wheel speed sensor clamp bolt (a): 11 N·m (1.1
kgf-m, 8.0 lb-ft)
4
3
7) Tighten parking cable clamp bolt (1) to specified
torque and then connect parking cable clamp (2).
Tightening torque
Parking cable clamp bolt (a): 25 N·m (2.5 kgf-m,
18.0 lb-ft)
2
8) Install upper arm referring to "Upper Arm Removal
and Installation".
9) Install rear suspension knuckle referring to "Rear
Suspension Knuckle Removal and Installation".
10) Install rear drive shaft referring to "Rear Drive Shaft
Assembly Removal and Installation: Rear in Section
3A".
11) Install lower arm referring to "Lower Arm Removal
and Installation".
2
1,(a)
4
4
I5JB0A230052-01
1,(a)
I5JB0A230053-01