Suzuki Grand Vitara 2011 Manual page 888

2B-16 Front Suspension:
15) Support suspension frame at the specified positions
(1) indicated in figure.
WARNING
!
When removing suspension frame, be sure to
apply some supporting equipment under it at
well-balanced position as shown in the figure
section so as to prevent from its drop.
1
16) Remove engine front body side mounting nuts (1).
17) Remove suspension frame mounting bolts (2), and
then lower suspension frame (3) with stabilizer bar,
P/S gear box assembly and front differential
assembly (if equipped).
1
2
1
I5JB0A220047-01
2
3
I6JB01220007-01
18) Remove P/S gear box assembly (1) and front
differential assembly (2) (if equipped) referring to "P/
S Gear Case Assembly Removal and Installation in
Section 6C" and "Front Differential Dismounting and
Remounting: Front in Section 3B".
19) Remove stabilizer bar (1) and bushing (2) from
suspension frame (3).
2
Installation
1) When installing stabilizer, loosely assemble all
components while insuring that stabilizer is centered,
side-to-side.
2) Install stabilizer bar (1), stabilizer bushing (2) and
stabilizer mounting bracket (3) to suspension frame.
NOTE
• For correct installation of stabilizer bar,
side-to-side, be sure that stopper ring (5)
on stabilizer bar aligns with stabilizer
bushing, both right and left, as shown in
figure.
• Install stabilizer bushing so that a cut (6)
becomes forward.
1
2
I5JB0A220049-01
1
2
3
I5JB0A220050-01