Compressor Assembly Removal And Installation (F9Q Engine Model); Magnet Clutch Components For M16 Engine Model - Suzuki Grand Vitara 2011 Manual

7B-85 Air Conditioning System:
Compressor Assembly Removal and
Installation (F9Q Engine Model)
Removal
1) Run engine at idle with A/C ON for 10 minutes.
2) Disconnect negative (–) cable at battery.
3) Recover refrigerant from the A/C system using
recovery and recycling equipment referring to
"Recovery" in "Operation Procedure for Charging A/
C with Refrigerant".
NOTE
The amount of compressor oil at removed
must be measured and the same amount
must be poured when installing the
compressor.
4) Disconnect MAF sensor coupler, and then remove
air cleaner assembly.
5) Remove A/C compressor drive belt referring to
"Accessory Drive Belt and Idler Pulley Removal and
Installation: For Diesel Engine Model in Section 1J".
6) Disconnect magnet clutch connector.
7) Disconnect suction hose and discharge hose from
compressor.

Magnet Clutch Components for M16 Engine Model

9
6
8
(b)
1. Armature plate bolt
2. Armature plate
3. Circlip
4. Magnet clutch
S6JB0A7206049
2
1
(a)
5. Shim(s)
6. Magnet clutch coil
7. Compressor body assembly
8. Magnet clutch coil bolt
NOTE
Cap open fitting immediately to keep
moisture out of system.
8) Remove compressor from its mount.
Installation
CAUTION
!
Be sure to use HFC-134a (R-134a)
compressor oil.
Reverse removal procedure noting the following
instructions.
• If compressor is replaced, pour new compressor oil
referring to "Precautions on Replenishing Compressor
Oil".
• Evacuate and charge system referring to "Evacuation"
and "Charge" in "Operation Procedure for Charging A/
C with Refrigerant".
• Install drive belt referring to "Accessory Drive Belt and
Idler Pulley Removal and Installation: For Diesel
Engine Model in Section 1J".
Tightening torque
Compressor mounting bolt: 25 N·m (2.5 kgf-m,
18.0 lb-ft)
7
3
5
9. Thermal switch
: 15 N⋅m (1.5 kgf-m, 11.0 lb-ft)
: 4.9 N⋅m (0.49 kgf-m, 4.0 lb-ft)
: Do not reuse.
S6JB0A7206036
4
I5JB0A720060-01