Suzuki Grand Vitara 2011 Manual page 961

23) Upon completion of gear tooth contact check in Step
22), caulk flange nut (2) with caulking tool (1) and
hammer.
24) Clean mating surface of differential carrier (2) and
rear cover (1), apply sealant to carrier as shown in
figure by such amount that its section is 1.5 mm
(0.059 in.) in diameter, mate rear cover with
differential carrier, and then tighten bolts to specified
torque.
"A": Sealant 99000–31260 (SUZUKI Bond
No.1217G)
Tightening torque
Rear cover bolt No.1 (a): 50 N·m (5.0 kgf-m, 36.5
lb-ft)
Rear cover bolt No.2 (b): 60 N·m (6.0 kgf-m, 43.5
lb-ft)
1
I1JA01322021-01
(a)
2
(b)
2, "A"
I6JB01321001-03
25) Assembly front drive shaft retainer as follows.
a) Install front drive shaft bearing (1) using special
tool, and then install snap ring.
Special tool
(A): 09913–75520
b) Apply grease to oil seal lip, and then install oil
seal (1) using special tools as shown in figure.
Distance between retainer surface and oil
seal
"a": 4.7 – 5.2 mm (0.185 – 0.205 in.)
"A": Grease 99000–25010 (SUZUKI Super
Grease A)
Special tool
(A): 09924–74510
(B): 09951–16090
Differential: Front 3B-16
(A)
1
I5JB0A321043-01
I5JB0A321044-01